I didn’t think spending a couple more bucks on filament would make a difference. Honestly, I’ve always been the type to grab whatever budget spool I could find on Amazon. It always got the job done—functional parts, decent strength, nothing fancy. But the first time I tried the OVERTURE PLA Filament 1.75mm (White, 1kg), my prints came out so smooth that I actually double-checked my printer settings to make sure I hadn’t accidentally dialed something in perfectly.

Why I Gave It a Shot

I grabbed this filament mostly because I wanted a white base color I could paint over. Black and gray had been my go-tos before, but white seemed like a good “blank canvas” option. Overture was a few dollars more than the cheapest roll—around $16 compared to $12–13—but still in the affordable range. Plus, I liked that the spool itself was cardboard and recyclable. A small detail, but it made me feel like I wasn’t adding more plastic waste to the pile.

The Difference I Noticed

On my very first print, the difference was obvious. The sides were smoother, the little layer inconsistencies that I’d almost gotten used to seeing were just… gone. I didn’t tweak my slicer or my temps—I ran the same settings I used with cheaper filament, but the results looked like I had upgraded my printer itself.

It wasn’t just cosmetic either. Prints felt more consistent and solid in my hand. I wasn’t sanding off blobs or trimming strings nearly as much. It’s weird to say this about filament, but the prints just felt “cleaner.”

A Real-World Test

The real proof came when I printed a small case for an ESP32 project. Normally, on something like that, I’d expect to see little surface imperfections or spots where the walls didn’t line up perfectly. With this Overture roll, it came out looking nearly professional—like something I could have ordered from a small-batch manufacturer. I actually ended up painting over the white with a matte black, and it looked incredible because the base surface was so smooth to begin with.

One Small Drawback

If I had to nitpick, the only “issue” is that white shows dust and fingerprints more than darker colors. If you’re not planning to paint or finish your prints, that’s something to keep in mind. But since my main use for white is as a base color, it’s not a dealbreaker at all.

Final Thoughts

I didn’t expect a $3 price difference to completely change my 3D printing experience, but it did. Overture’s white PLA has honestly made me rethink how much those small upgrades in material matter. If you’re tired of dealing with rough finishes and want something that just works better out of the box, I’d say give this a try.

👉 Check it out here: OVERTURE PLA Filament 1.75mm (White, 1kg)